DuPont WFDW120009W Instruction Manual Page 6
- Page / 11
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Universal Drinking Water Series
5
V4.2
STEP
5
Install the Filter and Test the Filter System for Proper Operation
1 Insert the new Filter Cartridge over the standpipe in the bottom of the Filter Housing.
2 Screw the Filter Housing back onto the System Head and hand-tighten. Using the Filter Housing Wrench, tighten 1/4 turn.
NOTE: Do not over tighten.
3 Check for any leaks before proceeding.
4 Turn on the cold water shut-off valve and turn on the faucet. Flush the system for 10 minutes.
5 Slowly turn on the cold water shut-off valve underneath the sink.
6 Turn on the kitchen faucet. In order for the Filter System to flush the Filter Cartridge, allow the water to run for approximately
10 minutes.
7 Check for any leaks between the System Head and Filter Housing of the Filter System, and on the inlet and outlet connections.
If there are leaks between the System Head and Filter Housing of the Filter System:
Turn off the cold water shut-off valve underneath the sink.
Turn on the kitchen faucet to release pressure and allow water to completely drain from the line.
Unscrew and remove the Filter Housing from the System Head using the Filter Housing Wrench
F .
NOTE: Use a pan or bucket to catch any water in the housing.
Remove the Filter O-Ring C and inspect. Clean and lubricate with silicone grease.
Clean the grooves in the top of the Filter Housing where the Filter O-Ring sits.
Place the clean, lubricated Filter O-Ring back in the groove.
Screw the Filter Housing back onto the System Head and hand-tighten. Using the Filter Housing Wrench, tighten 1/4 turn.
Turn on the cold water shut-off valve underne
ath the sink. Turn on the kitchen faucet. Inspect for leaks.
If there are leaks between the fittings and shut-off valve, flexible tubing or rigid tubing:
Turn off the cold water shut-off valve underneath the sink.
Turn on the kitchen faucet to release pressure and allow water to completely drain from the line.
Tighten all fittings securely.
Turn on the cold water shut-off valve underneath the sink.
Turn on the kitchen faucet. Inspect for leaks.
If leaks continue, disconnect all fittings and add plumber’s tape to threads and retighten.
If there are leaks between the System Head and the 1/4" Plastic Tubing:
Turn off the cold water shut-off valve underneath the sink.
Turn on the kitchen faucet to release pressure and allow water to completely drain from the line.
Disconnect the 1/4" Plastic Tubing from
the System Head Inlet and System Head Outlet.
Check the 1/4" Plastic Tubing to see if it is cut squarely. If not, re-cut the ends squarely.
Wet the ends of the 1/4" Plastic Tubing with water and re-insert into the System Head Inlet and System Head Outlet.
Turn on the cold water shut-off valve underneath the sink. Turn on the kitchen faucet. Inspect for leaks.
If leaks continue, turn off the
water
supply and call Customer Service.
5
STEP
FLEXIBLE TUBING INSTALLATION
RIGID TUBING INSTALLATION
Related products and manuals for Sanitary ware DuPont WFDW120009W
(20 pages)Naxa Impianti HiFi manuali utente
La lista di Naxa Impianti HiFi prodotti contiene 5 manuali utenti per 3 modelli. Tutte le guide utenti pdf sono disponibili per essere scaricate o visionate online.
Comments to this Manuals