DuPont WFQT130005 Instruction Manual download pdf (Page 7)

STEP 5

Install 1/4" Plastic Tubing for Water Supply Line from

Kitchen Faucet Adapter to System Head Inlet

1 Determine the length of 1/4" Plastic Tubing L that will be necessary to connect the System Head Inlet to the Kitchen Faucet

Adapter

H. Make sure to allow enough Plastic Tubing to prevent kinking in the line.

2 Cut the 1/4" Plastic Tubing squarely on both ends.

3 Wet one end of the 1/4" Plastic Tubing with water and push it into the Kitchen Faucet Adapter approximately 5/8" until it stops.

NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.

4 Wet the other end of the 1/4" Plastic Tubing with water and push it into the System Head Inlet approximately 5/8" until it stops.

NOTE: The 1/4" Plastic Tubing does not need to be disconnected for general routine maintenance and filter replacement. However,

Plastic Tubing may be easily disconnected if necessary. Simply turn off the water supply to the Filter System and press in the grey collar

around the fitting while pulling the Plastic Tubing out with the other hand.

STEP 6

Install 1/4" Plastic Tubing for Water Supply Line from

System Head Outlet to Faucet

1 Determine the length of 1/4" Plastic Tubing L that will be necessary to connect the System Head Outlet to the threaded Faucet

Stem. Make sure to allow enough Plastic Tubing to prevent kinking in the line.

2 Cut the 1/4" Plastic Tubing squarely on both ends.

3 Wet one end of the 1/4" Plastic Tubing with water and push it into the System Head Outlet until it stops.

4 Gently slide the plastic Compression Nut down G (thread side up) over the tubing. Follow with the plastic Ferrule J, making sure

that the Ferrule is in the proper position with the larger opening on the bottom (going into the nut). Place the plastic Insert

I into

the end of the 1/4" Plastic Tubing.

5 Firmly push the 1/4" Plastic Tubing into the end of the threaded Faucet Stem. Hand-tighten the plastic Compression Nut onto the

threads. Tighten with an adjustable wrench approximately 1/2 turn.

NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting. Do not over tighten the Compression Nut.

FAUCET FOR

FILTERED WATER

1/4" PLASTIC TUBING

INLET OUTLET

HOT WATER

ALVE

1/4" PLASTIC TUBING

COLD WATER

ALVE

5/8"

V4.0

WFQT13000 & WFQT13500 Series

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

DuPont WFQT130005 Instruction Manual Page 7